Method A - Application Guide

Suitable for all metal surfaces including bronze, stainless steel and aluminium and is applied using heat as a penetration catalyst (Note that more detailed written instructions for both methods are included with your Propshield purchase along with further detailed precautions). Further application photos can be seen here.

WARNINGS:
1) Do not use Method A on painted surfaces, i.e. outdrive legs and outboards however you can use either method on your outdrive/outboard propellers if the blades on are bare metal.
2) Do not overheat outdrive/outboard props as the rubber insert/seals in some designs of prop hub can be damaged. If unsure check with the manufacturer of your outdrive or outboard motor.

The below example/guide shows Propshield being applied to a bronze propeller.

Surface Preparation:
First clean the metal surface

Heat the surface
(in this case the propeller)
with a blow lamp or heatgun.

Once the first coat has been applied
over the whole surface melt some Propshield into a metal container
until it is a liquid.

Now with a rag wipe
Propshield onto the propeller blade until a very thin film is applied and then work vigorously  into the metal surface

Now brush on a second
thicker coat

The job is now completed and
the vessel is ready to launch.